Clippunch
Bear
Each set contains 2 punches
One is a standard shape punch, which can be used normally. One is the Clippunch, which allows you to turn the shape into a clip.If punching clips, the Clip Punch must be used FIRST. For projects and inspiration check out these books Clippunch II and Clippunch III.
Instructions for use:
Each pack contains two punches. One is a regular craft punch and can be used normally to punch shapes. The second punch is the 'clip' punch.
To punch out the 'clips':
1. Take the 'clip' punch and punch the shape on paper or thin card.
2. Take the 'shape' punch & align it over the clip. So that the punched clip is in the centre
3. Punch out the shape, and you will have your 'clip' shape.
The same instructions apply when using the ribbon and threading punches.
The Ribbon & Threading pack can be used with other shaped punches you already have. Just remember to punch out the 'ribbon' cut first. The Ribbon punch can also be used down the edges of card blanks for an unusual finish
WAS £4.95
